thermite

again i dont know if i should teach some of you this

Thermite is nasty shit. Here is a good and easy way to make it. The first step is to get some iron-oxide (which is RUST!). Here is a good way to make large quantities in a short time:

– Get a DC convertor like the one used on a train set. Cut the connector off separate the wires and strip them both.
– Now you need a jar of water with a tablespoon or so of sodium chloride (which is SALT!) added to it. This makes the water conductive.
– Now insert both wires into the mixture (I am assuming you plugged the convertor in…) and let them sit for five minutes. One of them will start bubbling more than the other. This is the POSITIVE(+) wire. If you do not do this test right the final product will be the opposite (chemically) of rust which is RUST ACID. You have no use for this here (although it IS useful!).
– Anyway put the nail tied to the positive wire into the jar. Now put the negative wire in the other end. Now let it sit overnight and in the morning scrape the rust off of the nail & repeat until you got a bunch of rust on the bottom of the glass. Be generous with your rust collection. If you are going through the trouble of making thermite you might as well make a lot right?
– Now remove the excess water and pour the crusty solution onto a cookie sheet. Dry it in the sun for a few hours or inside overnight. It should be an orange-brown color
– Crush the rust into a fine powder and heat it in a cast-iron pot until it is red. Now mix the pure iron oxide with pure aluminum filings which can be bought or filed down by hand from an aluminum tube or bar. The ratio or iron oxide to aluminum is 8 grams to 3 grams.
– Congrats! You have just made THERMITE! Now to light it…
– Thermite requires a LOT of heat (more than a blow torch!) to ignite. However a magnesium ribbon (which is sorta hard to find.. call around) will do the trick. It takes the heat from the burning magnesium to light the thermite.
– Now when you see your victim’s car pour a fifty-cent sized pile onto his hood stick the ribbon in it and light the ribbon with the blow torch. Now chuckle as you watch it burn through the hood the block the axle and the pavement. BE CAREFUL! The ideal mixtures can vaporize CARBON STEEL! Another idea is to use thermite to get into pay phone cash boxes. HAVE FUN!!

Advertisements

About this entry